Trane CGA Series, Installation Operation & Maintenance

Page: 3 / 24

Overview
Warranty
A. Warranty is based on the general terms and conditions of the manufacturer. The warranty is void if the equipment is
repaired or modified without the written approval of the manufacturer, if the operating limits are exceeded or if the control
system or the electrical wiring is modified. Damage due to misuse, lack of maintenance or failure to comply with the
manufacturer’s instructions or recommendations is not covered by the warranty obligation. If the user does not conform
to the rules of this manual, it may entail cancellation of warranty and liabilities by the manufacturer.
B. Warranty is twelve (12) months as from the date of first start up at installation place or eighteen (18) months after
delivery at the project or other delivery location indicated by the customer. The date the unit is operated for the first time
means the date reported in the “1st start up form” contained into the “unit log book”. This form should be filled in and
sent, within 8 days from the start up, to Trane.
C. The warranty is valid if all the installation and start-up instructions have been adhered to (both those which may have
come from Trane and those coming from current practice), if the
“1st start up form” has been filled in and sent to the
Trane after sales department.
D. The warranty is subject to any faults or defects being reported within eight days from their discovery. The warranty will
only be applied if and when the purchaser suspends use of the equipment as soon as a defect has been found.
E. The warranty is valid if the first running of the unit is carried out by a Trane authorized assistance center.
F. The warranty is subject to regular maintenance of the unit which is appropriately indicated in the “unit log book” locat-
ed inside the electrical panel.
G. Warranty automatically ends in case of payments not fulfilled, non-performance of the contract and even if the units
show tampering without TRANE written approvals.
Receiving the unit
On receiving the unit, it is up to the customer to check that there is no obvious damage or pieces missing. If this is so, an
immediate complaint must be made to the carrier for damage or for not-delivery and the Receiving Card to be found
inside the unit electrical panel must be filled in. Photographic evidence must be provided for macroscopic damage. The
card must be sent to Trane within 8 days of receiving the goods: if it is not sent back or delayed, the complaint will not be
accepted.
Factory inspection
Units are inspected in the factory, in appropriate areas, in accordance with internal procedures. Each performance test
carried out on the unit is possible only if the same conditions are reproduced and maintained (charge consistency,
constant temperature and evaporation - condensation and recovery capacity, quality and tolerance of the measuring
instruments etc.) in the test rooms.
The inspection conditions are those indicated by the customer in the ordering phase: if not otherwise specified, reference
should be made to the nominal performance indicated in the product catalog in force at the date of the Confirmation of
the Order.
Improper uses
The unit is projected and built up to grant the maximum safety in its proximity, as well as to resist to the aggressive
environmental conditions. The fans are protected by grilles. Residual risks are indicated with warning labels.
SAFETY SYMBOLS
DANGER: DANGER: DANGER: DANGER:
General danger Temperature Moving parts Cut off
voltage