36
TK 56403-2-IM-EN
a.
Slide supplied heat shrink tubing onto each wire and position them away from joint.
b.
Connect each wire with wire connector and crimp securely.
c.
Solder wires to wire connectors with a soldering gun.
d.
Slide heat shrink tubing over each wire connector and applying heat with a heat gun.
e.
Secure harness inside the control box with tie bands.
UFLS Harness Connections
1.
Cut the interconnect harness to length and splice wires to the fuel sensor’s leads (Item 2).
Connections at Sensor
BLACK to BLACK
WHITE to YELLOW
GREEN to RED
a.
Slide supplied heat shrink tubing onto each wire and position them away from joint.
b.
Connect each wire with wire connector and crimp securely.
c.
Solder wires to wire connectors with a soldering gun.
d.
Slide heat shrink tubing over each wire connector and applying heat with a heat gun.
2. Secure any exposed harness with clamps (Item 3).
3. Install the UFLS sensor assembly in position on the Fuel Tank (Item 4).
a. Remove the five screws of the protective cover.
b. Install the gasket provided, and then install the Ultrasonic Fuel Sensor assembly in place.
c. Secure with the 5 screws/washers provided.
IIm
mp
po
orrtta
an
ntt:: This is a “Solid State” fuel level sensor and the SR-3 Controller must be programmed accordingly to enable
the fuel level feature.
