63
TRAK Machine Tools
Southwestern Industries, Inc.
TRAK TRL Lathe, ProtoTRAK RLX CNC Safety, Installation, Maintenance, Service & Parts List
error log press the F6 softkey. The page forward and backward keys allow you to scroll through the
file one page at a time. The data forward and data backward keys allow you to scroll through the
file one line at a time. The data bottom key takes you to the bottom of the file and then changes to
data top which will take you back to the top. The file will capture data until the file reaches a size of
approximately 600 KB. At this time the file is saved to a backup file and the original file is cleared
and data is once again captured. Once again as the file reaches a size of 600 KB it copies over the
previous backup file. From here the user can save the file to an external thumb drive by pressing
the F8 softkey. Once this in done it prompts for which file you want to save to disk. The F1 key
saves the current file to disk and the F2 key saves the backup file to disk. To clear the files press
the F7 softkey.
4.8.3.8
Code 326: Look Up Message
Allows user to display safety flashing messages, master messages and slave error messages on
screen. Often used by translators converting English language to some other language.
4.8.3.9
Code 327: Display Memory Check
Displays memory availability of various devices.
4.8.4 Operator Defaults/Options Codes
The following codes allow the user to set programming defaults or turn features on or off. To get
to any of these codes go to Service Codes, press “D” and press the code you wish to view.
4.8.4.1
Code 79: Beeper On
This turns on the beeper to the control keys.
4.8.4.2
Code 80: Beeper Off
This turns off the beeper to the control keys.
4.8.4.3
Code 143: Toggle Tool Change Spindle Mode
This code allows the spindle to stay on at tool changes when turned to the ON position.
4.8.4.4
Code 328: EPA On/Off
Turn the EPA feature on or off
4.8.5 Lube Pump Codes
The following codes are used for programming and operating the lube pump. To get to any of
these codes go to Service Codes, press “E” and press the code you wish to view.
4.8.5.1
Code 300: Lube Pump Switch
This code acts as a switch to turn the lube pump on for the programmed time set in Code 302.
4.8.5.2
Code 301: Set Lube Pump cycle time
This code sets the interval time between lube cycles.
4.8.5.3
Code 302: Set Lube Pump discharge time
This code sets the lube pumps discharge time.
