48
Southwestern Industries, Inc.
TRAK
KMX Knee Mill, Bed Mill & ProtoTRAK
KMX CNC Retrofit Safety, Programming, Operating & Care Manual
FIGURE 7.3.6.2
Holes 1-4 are mirrored across the Y axis to 5-8, respectively,
about a line X OFFSET from X=absolute 0
Press the
SUB
soft key to call up the Repeat, Rotate and Mirror options.
7.3.7
Finishing Teach Events
Teach events are either POSN/DRILL or MILL events that are originated in the
DRO Mode (see Section 6.5).
The Teach events that are started in the DRO Mode must be finished in the
Program Mode before running. Teach events are of these different types:
TEACH POSN/DRILL
- See Section 7.3.1 for a description of Position/Drill
event prompts.
TEACH MILL
- a straight line that specifies the beginning and the end. When
TEACH MILL events are defined using the CONT MILL softkey, the prompts for
information that cannot change will be suppressed. See Section 7.3.2 for a
description of Mill event prompts.
When a Teach event is unfinished, the event header will appear in purple. Once
all the prompts are completed, the word “Teach” will disappear. The event will
become a normal POSN DRILL or MILL event.
7.4
Programming Events
–
(3-axis mode)
The following events are found in the TRAK KMX machine when running in 3-axis mode.
7.4.1
Posn Drill
When you press the POSN/DRILL key, you choose between the following:
