32
TRAK Machine Tools
Southwestern Industries, Inc.
Airwolf EVO 3D Printers - Installation, Printing, Maintenance & Troubleshooting Manual
4.1.5.
Material & Nozzle Change Procedures
(if needed)
This section covers most filament and nozzle change procedures. Please ensure that steps are followed
exactly as outline below, to avoid possible damage to the printer.
4.1.5.1.
Pre-Heating the Nozzles, Bed, Chamber or All
Steps
Images
1.
Select PREHEAT
2.
Select the material you loaded.
3.
You may preheat multiple components at
once, one at a time, or select ALL to pre-
heat both nozzles, the print bed and
chamber.
4.
Then, press DONE.
5.
Pre-heating will begin, and you will see
“PRE
-
HEATING” flashing in the s
creen.
Once preheated, the flashing sign will go
away.
