Yard-Vue
TM
QUICK START GUIDE
System Contents:
SETTING UP THE CAMERA
Wireless
APP Camera
Camera Stand Camera
Antenna
x 1
x 1
x 1
Power
Adapter
x 1
x 1
Quick Start
Guide
x 1
x 1
Screw Pack
1. APP DOWNLOAD
Please download and install the "OMGuard HD" APP to
your device.
2.Power the camera
Plug the camera in to a mains supply, via the supplied power
adapter, and check that the Red & Green LEDs are flashing,
which indicates the camera is ready for Wi-Fi setup. This process
should be completed within 1min; ensure that both LEDs are
flashing Red & Green.
3a. Direct Wireless Connection:
(1) Go to the Wi-Fi setting on your mobile device. Choose the Wi-Fi router with a
prefix of HD-xxxxxx (xxxxxx = Camera ID numbers). Enter the
default password
12345678
and 'save' the settings.
3b. Alternatively, establish a connection via the Ethernet cable:
(1) Connect your mobile device to the Wi-Fi router. Connect the camera to the Wi-Fi router
with the supplied Ethernet cable. After powering the camera, it will take approx 40 seconds
to connect to the router. When completed/connected the green LED will stay ON.
(2) Launch the APP, tap the “Search” button to locate the camera.
(3) Enter the default password
123456
then 'save' the settings.
4.Wi-Fi Setting
4a.
4b. The camera will be offline for around 40 seconds to reboot for Wifi connection. When
the camera connects to the Wi-Fi router correctly, the Green LED will stay ON.
4c. In the Wi-Fi settings of your smart phone/tablet, make sure that he Wi-Fi router you are
connecting to is the same one as the camera. If not, manually connect to it.
Note:
Be sure to
choose your local home Wi-Fi router on your local network in the App
ADVANCED SETTINGS. The system will begin to count down and reboot the system.
The camera view will show on screen again after the Wi-Fi setting has been updated.
Note:
Wi-Fi setting may fail if you leave the ethernet cable connected. Please remove the cable
after settings have been completed.
Note:
If the LEDs are not flashing, Red & Green, press and hold the
reset button for 5 seconds until the Red & Green LEDs start to flash.
Advanced
Enter Admin
Password (
default
123456
)
Choose the appropriate
Wi-Fi router for your local
network
(2) Launch the APP, tap to add the camera.
(3) Tap (QR code icon) and scan the QR code label on the back
of the camera to bring up the DID information. Or tap "search"
and select the camera DID (also printed on the camera label).
(4) Enter the
default password 123456
and 'save' the settings.
Note:
For video recording,
ENSURE
that a
CLASS 10
memory card or above
(8GB supplied)
is utilised, as other kinds of
memory card may cause unexpected results and should be avoided.
For iOS
For Android
USB to RJ45
Connector
Antenna
Motion
Sensor
2
3
4
USB to RJ-45
Cable
8GB Micro
SD
x 1
V1 Jun19
