User Manual
TRAQC-8 DPC
TRAQC-8 DPC 11/2016 EN Rev.3
Sheet 21
To overwrite the automatic switching between the two pressure sensors, one
of the sensors can be selected as described in 3.11.
To enable the auto ranging again:
Power the TRAQC-9 P off and start it up again.
By entering the ‘Pressure range’ menu, and selecting the
‘Px auto ranging’ line with the ‘ARROW’ keys and press the ‘ENTER’
key (F1).
3.12
Instrument Status
By pressing the ‘LEFT’-or “RIGHT’ ‘ARROW’ key in “measuring mode” the
instruments status is shown.
4
User Configuration
4.1
Pressure Setup
The “Pressure Setup” menu shows the options for pressure inputs.
After pressing the ‘MENU’ key (F1), press the ‘ARROW’ keys until the
“pressure setup” is selected, then press ‘ENTER’ key (F1). The available
pressure options for the instrument are now displayed (see figure) and it is
now possible to select one of options with the ‘ARROW’ keys. The different
options of the pressure setup are described in the following paragraphs.
4.1.1
Pressure range
This menu option is available in instruments with 2 or more pressure
sensors installed.
When you select this option a menu with the available pressure ranges is
shown,
You can select a line with the arrow keys and then switch the selected
pressure range on or off depending upon its current status when the
electrical ranges are not active, otherwise you can select only one range to
be displayed. See also section 3.11.
4.1.2
Pressure unit
The menu to select the pressure unit can in most operating modes be accessed by pressing the ‘UNIT’ function
key, There are however operating modes where this is not possible , for these modes the pressure unit
selection is also available in the pressure setup menu, see section 3.10.
