User Manual
TRAQC-8
TRAQC-8 04/2017 EN Rev.4
page : 19
3.1.5
Resolution Setup
To change the number of digits (from 3 to 6) select “resolution
setup” in the “pressure setup” menu and use the ‘ARROW’ keys to
change the number of digits, confirm by pressing the ‘ENTER’ key
(F1)
3.1.6
Conversion Table
The pressure indicator is capable of displaying
pressure according to the SI or the ANSI
standards. Change between SI and ANSI using
the ‘ARROW’ keys and confirm by pressing
‘ENTER’
key (F1).
The ANSI standard has other conversion
factors than the SI standard; see the following
table for a number of units:
3.1.7
Set customer unit
The density of seawater for the region where the pressure
indicator is used can be set here.
When a test pressure is set, the TRAQC-8 can calculate the
pressure into meters under water. The density of the seawater
will differ in different parts of the world and the value has to be
adjusted for correcting for the pressure under water.
The seawater density is set in kg/m
3
and can be adjusted from
950 up to and 1100 kg/m
3
.
For adjusting the unit, use the left and right arrow keys to select
the digit which has to be altered and use the up and down arrow
keys for adjusting the selected digit. When the right value has
been set, press the enter key (F1).
Unit
SI
ANSI
01
bar
1
1
02
mbar
1000
1000
03
Pa
100000
100000
04
hPa
1000
1000
05
kPa
100
100
06
Mpa
0,1
0,1
07
psi
14,503768
14,503768
08
kgf/cm²
1,0197162
1,0197162
09
mmH²O
10197,162
10215,491
10
cmH²O
1019,7162
1021,5491
11
mH²O
10,197162
10,215491
12
inH²O
401,46293
402,1598
13
ftH²O
33,455222
33,513316
14
mmHg
750,063755
752,78742
15
inHg
29,52997
29,6373
16
torr
750,063755
750,063755
