User Manual
TRAQC-3 FM
TRAQC-3 LH 10/2014 EN Rev.2
page : 9
2.6.
Specifications
Temperature range
: A5°C to 375°C.
Resolution
: 0,1 °C/°F.
Accuracy
: Over full range better than +/- 0,4 °C, typ. +/- 0.2°C
Stability
: +/- 0,05 °C.
Heating time
: Ambient to 300 °C 5.75 minutes.
Cool down time
: 300 °C to 60 °C 14 minutes.
Stabilization
: 5 minutes.
Well depth
: Max 100 mm.
Switch test
: Powerless switch, LED indicator, 5 VDC, 16 mA max.
Communication
: RS232 for use with e.g. AutoCal
Supply voltage
: 230Volt, 50/60 Hz or 110 Volt, 50/60 Hz. Selectable.
Power consumption
: 250 Watts.
Fault protection
: Internal sensor break detection.
Fuse
: 3.15 A .
Thermal Protection switch : 75 °C
Temp switch test
: 5 VDC, 16 mA max.
Safety
: EN 61010-1:2010/C1:2011, EN61010-2-010:2014.
Conformity EMC
: EN-61326-1:2013
Weight
: approx 1740 grams, without powercord, incl. 6.2 mm insert.
Dimensions
: w x d x h : 149 x 159 x 74 mm.
All specifications at 20°C +/- 2°C.
2.7.
Maintenance
Allow the TRAQC-3 to cool down as described in chapter 2.4.
Switch the TRAQC-3 off and disconnect the mains plug.
Cleaning TRAQC-3 with inserts:
A small amount of dust or pollution can cause jams when the instrument is operated
with inserts. To prevent this, remove the insert from the heating block at regular
intervals and if the TRAQC3 is not going to be operated for a longer period. Flush the
heating block bore with compressed air and clean the bore and inserts with a dry cloth.
Cleaning the fan grille:
Each TRAQC-3 is fitted with a small air grille via which cooling air enters the TRAQC-3.
Clean the grille at regular intervals (vacuuming or brushing) depending on the level of air
pollution.
External cleaning:
Clean the outside of the TRAQC-3 with a damp cloth and some water or with a
solvent-free mild cleaning agent. Disconnect the instrument from mains before cleaning.
Fuse:
Two Fuses of 3.15Amp (slow) need to be used.
