Product Code: TQBJ12TA
Made in China to TQB Brands Pty Ltd Specifications
Page 5
Visit us at www.tqbbrands.com.au
Bleed Air for Air Motor:
1.
Remove the Oil Filler Bung and if required, refill with *32 Grade hydraulic oil until the oil is
lapping the bottom of the Oil Filler Hole.
2.
Leave the Oil Filler Bung out, turn the Release Valve ‘clockwise’ to the lift position and
pump the Pump Socket ‘up and down’ to raise the Lift Ram to full extension.
3.
Replace the Oil Filler Bung, then turn the Release Valve ‘anticlockwise’ to the lowering
position until the Lift Ram returns to the fully lowered position.
(Note: Depress the Saddle where necessary)
4.
Turn the Release Valve ‘clockwise’ to the raise position. Connect an air supply to the
Air Trigger assembly and depress the trigger, holding down until the Lift Ram is fully
extended.
5.
Remove the Oil Filler Bung, then turn the Release Valve ‘anticlockwise’ to the lowering
position until the Lift Ram returns to the fully lowered position.
(Note: Depress the Saddle where necessary)
6.
Replace the Filler Bung and turn the Release Valve ‘clockwise’ to the raise position.
Connect an air supply to the Air Trigger assembly and depress the trigger, holding down
until the Lift Ram has extended to full stroke then...
...continue to hold the trigger down for 10 seconds.
7.
Turn the Release Valve ‘anticlockwise’ to the lowering position until the Lift Ram returns
to the fully lowered position. (Note: Depress the Saddle where necessary)
At this point the Manual Pump, Air Motor Pump and Lift Ram should be free of air and the Jack ready for Operation.
If the Jack continues to show the Symptoms as above, please refer to a Qualified Hydraulic Technician.
3.
OPERATION
Prior to each use always conduct a visual inspection checking for and any abnormal conditions, such as cracked welds, and
damaged, loose, or missing parts.
Raising the Jack:
1.
Block the vehicle's wheels for lifting stability. Secure the load to prevent inadvertent shifting and movement.
2.
Position the jack near desired lift point.
3.
Set the parking brake in the vehicle.
4.
Refer to the vehicle manufacturer owner's manual to locate approved lifting points on the vehicle. Position the jack so
the saddle is centred and will contact the load lifting point firmly
5.
Assemble the handle; ensure that spring clips align with slots.
6.
Close the release valve by turning it clockwise until it is firmly closed.
7.
Insert and secure the handle into handle sleeve. Pump handle or squeeze the lift control valve until the saddle contacts
load. To end air operation simply release the grip on the lift control valve.
8.
Raise load to the desired height, then immediately transfer the load to appropriately rated jack stands.
WARNING
Never wire, clamp or otherwise disable the lift control valve to function by any means other than by using the operator's
hand. Use the handle provided with this product or an authorised replacement handle to ensure proper release valve
operation. Do not use extensions on the air hose or on the operating handle.
Handle
(on Release Valve)
Pump
Socket
Saddle
Air
Motor
Oil Filler
Hole
Relief
Valve
Oil Filler Bung
Air
Fitting
Pump
Socket
Lift
Ram
Oil Filler Bung
Oil Filler Bung
Lift
Ram
Air
Trigger
Oil Filler Bung
Lift
Ram
Oil Filler Bung
Oil Filler Bung
Lift
Ram
Air
Trigger
Oil Filler Bung
