APR-22
Product Code: 2059T
Made in China to TQB Brands Pty Ltd specifications
Page 3
Visit us at www.tqbbrands.com.au
PRE-OPERATING SAFETY CHECKS
Save these instructions. For your safety, read, understand, and follow the information provided with and on this
500kg
Telescopic Transmission Lifter
before using.
•
DO NOT exceed the maximum lifting load capacity of 500kg.
•
ALWAYS loosen the air vent screw on side of hydraulic ram body before use.
•
Only use this transmission lifter on a surface that is stable, level, smooth, dry and capable of sustaining the load. Keep the
surface free from unrelated materials and ensure that there is adequate lighting.
•
DO NOT use on tarmac, or any other soft surface as the transmission may sink or topple.
•
Vehicle must be properly and adequately supported before commencing work with this transmission lifter.
•
This transmission lifter is used as an aid in the removal and installation of a transmission or a differential as individual
components. DO NOT use it for any other purpose than it is designed for.
•
Always centre the load on the saddle of this transmission lifter and be sure the transmission is stable and secure before
raising or lowering.
•
DO NOT use the transmission lifter to lift or support a heavy load such as a differential with axle or a transmission with
bell housing which is bulky and difficult to balance and may cause the transmission lifter to tip over and lead to equipment
damage and/or serious personal injury.
•
Never move this transmission lifter with a load any higher off the ground than necessary and always move it slowly and
carefully.
•
Transfer the load immediately to appropriate support device for service or repair.
•
DO NOT operate this transmission lifter when you are tired or under the influence of alcohol, drugs or any intoxicating
medication.
•
DO NOT allow untrained persons to operate this product and DO NOT make any modifications to this product.
•
DO NOT tamper with the safety valve.
•
DO NOT use brake fluid or any other improper fluid to refill or top up the hydraulic system of this transmission lifter. Only
use good quality ISOVG32 hydraulic oil.
•
DO NOT expose the transmission lifter to rain or any other kind of inclement weather.
•
Use a qualified person to maintain the transmission lifter in good condition. Keep the transmission lifter clean for best
and safest performance.
•
Use approved personal protection safety equipment such as eye protection, non-skid boots, full face impact shield and
heavy duty work gloves. Keep proper footing and balance, do not overreach.
WARNING:
Vehicle must be properly and adequately supported before commencing work with this Transmission Lifter.
INTENDED USE:
Designed for the removal, installation, and transportation (in the lowered position) of passenger vehicle transmissions that are
raised by an in-ground or above-ground lift.
STANDARD OPERATING PROCEDURE
DO NOT
use this machine unless you have been trained and assessed to a competent level in its sate use and operation, and
have been given permission to use this
Safety glasses must be worn when operating this
equipment
Long loose hair must be contained when operating
this equipment
Safety footwear must be worn when operating
this equipment
Close fitting/protective clothing must be worn
when operating this equipment
Rings and jewellery must not be worn when
operating this equipment
