警告與安全
/ Warnings & Safety/
Warnungen & Sicherheit/
Предупреждения и безопасность 127
WARNING:
To reduce the risk of electric shock or damage to the equipment:
Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at al
times.
Unplug the power cord from the power supply to disconnect power to the equipment.
Do not route the power cord where it can be walked on or pinched by items placed against
it. Pat particular attention to the plug, electrical outlet and the point where the cord extends
from the server.
WARNING:
To reduce the risk of personal injury or damage to the equipment:
Observe local occupation health and safety requirements and guidelines for manual
handling.
Obtain adequate assistance to lift and stabilize the chassis during installation or removal.
The server is unstable when not fastened to the rails.
When mounting the serverin a rack, remove the power supplies and any other removable
module to reduce overall weight of the product.
CAUTION:
To properly ventilate the system, at least 7.6cm (3.0 in) of clearance at the front
and back of the server should be provided.
CAUTION:
The server is designed to be electrically grounded (earthed). Only plug the AC
power cord into a properly grounded AC outlet to ensure power operation.
Electrostatic discharge
Preventing electrostatic discharge
To prevent damaging the system, be aware of the precautions to follow when setting up the system or
handling parts. A discharge of static electricity from a finger or other conducer may damage system
boards or other static-sensitive devices. This type of damage may reduce the life expectancy of the device.
To prevent electrostatic damage:
Avoid hand contact by transporting and storing products in static-safe container.
Keep electrostatic-sensitive parts in their container until they arrive at static-free workstations.
Place parts on a grounded surface before removing from their containers.
Avoid touching pins, leads or circuitry.
Always be properly grounded when touching a static-sensitive component or assembly.
Grounding methods to prevent electrostatic discharge
Use one or more of the following methods when handling or installing electrostatic-sensitive parts:
Use a wrist strap connected by a ground cord to a grounded workstation or computer chassis. Wrist
straps are flexible straps with a minimum of 1 mega-ohm +/ -10 percent resistance in the ground
cords. Wear the strap snug against the skin to provide proper ground.
Use heel straps, toe straps or boot straps at standing workstations. Wear the straps on both feet when
standing on conductive floors or dissipating floor mats.
