Revised 11/19/20 Copyright (C) 2020 Trade-Wind Manufacturing, LLC Proverbs 22:29 Page 1
INSTALLATION INSTRUCTIONS &
USE & CARE GUIDE
Trade-Wind
®
T7200 Series BBQ Hood
T7200 Series Models:
No Blower 1200 CFM
T7236 T7236-12
T7242 T7242-12
T7248 T7248-12
CONTENTS:
Part 1 - Planning the Installation
Part 2 - Electrical Connection
Part 3 - Direction of Vent and Securing the Hood
Part 4 - Use & Care
Before beginning installation, please thoroughly read and become familiar with these instructions. Installation and
service must be completed by a qualified installer. Failure to properly install this product may void the warranty.
Please be advised that the T7200 Series BBQ Hood MAY NOT be installed on a Patio or Lanai area that does not
have a roof over the BBQ Hood to protect it from direct rain or potential water ingress. This Hood should be
installed with a MINIMUM of three (3) feet of weather proof roof coverage on all sides that are not protected from
direct rain by an adjacent wall.
It is required that all duct work and roof openings be thoroughly sealed with the applicable tape and/or roof sealant
to prevent ingress of water.
Installer: Please leave Installation Instructions with the BBQ hood owner.
Owner:
Please keep Installation Instructions for local electrical inspector’s use and for future reference.
WARNINGS:
Must be followed carefully to avoid personal injury.
IMPORTANT:
Must be followed carefully to avoid damage or incorrect installation.
TIPS:
Contain helpful information to facilitate installation.
