Tracker Off-Road 800SX, Service Manual

Page: 37 / 192

35
LCD Gauge
REMOVING/INSTALLING
To remove the gauge, pull out on one side of it; then dis-
connect the multi-pin connector and remove the gauge.
MOD244A
To install the gauge, connect the multi-pin connector and
press the gauge into the dash.

NOTE: Ensure the rubber mounting ring is ori-
ented correctly on the tab and seats fully through the
dash.
MOD241
Front Wheel Alignment
 NOTE: All measurements and adjustments must be
made with the vehicle unloaded, steering rack aligned
with marks, steering wheel as shown at mid tilt and
both wheels straight.
PR087A
MOD162
Mark the centerline of the front tires at the front and
rear of the tire; then using a tape measure, measure and
record the distance between the marks at the front and
rear. The front measurement should be approximately
3-6 mm (1/8-1/4 in.) greater than the rear measurement
(toe-out).
MOD066A
To adjust the wheel alignment, use the following proce-
dure:
1. Using an open-end wrench to hold the tie rod ends
(A), loosen the right-side and left-side jam nuts (B).