background image

Remember, keep distortion out of the system and don’t use excessive volume which will cause unpleasant sound as the bass driver is
pushed beyond its limits.

High frequency attenuation
The Revo 8 is fitted with a 3-position rotary attenuator. This allows the tweeter to have low, medium or high power sent to it, as the switch
is turned clockwise more volume will be achieved from 2KHz upwards.
The reason for fitting this control is that very few install cabinets provide a balanced dynamic sound at all volume levels. When required
levels are low the attenuator should be set fully clockwise and if high volumes are required then the tweeter can be turned down. Careful
use of this attenuator will allow for maximum intelligibility of the reproduced music and in most situations position 2 will give a balanced
sound at moderate volume levels.

Warranty
All TRACE ELLIOT products carry a 2 year warranty which covers manufacturing defects. Loudspeakers rarely fail for any other reason
than coil burn out due to distortion or serious over-powering and these failures are not covered.
In the unlikely event of a failure then please refer to your Trace dealer or contact our service department on +44 (0)1621 840959.
Thank you for taking the time to read this manual and if all the precautions are followed the units should give many years of trouble-free
service.

Technical specifications
Model

Revo 8

Revo 10

Type 

2-way reflex

2-way reflex

Tweeter

Ferroelectric transducer

Celestion HF50 1.5” voice coil

Bass

8”

10”

Sensitivity

90dB

90dB

Impedance

8 ohms

8 ohms

Power

100 Watts

150 Watts

Crossover

2KHz 6dB/OCT

4KHz 12dB/OCT

Connection

Wire trap / jack

Speakon / jack

Freq. response

60-22000Hz

50-17000Hz

Height mm

435 (525 packed)

530 (625 Packed)

Width mm

320 (405 packed)

395 (485 packed)

Depth mm

285 (365 packed)

425 (425 packed)

Weight

6.2 Kgs

10.5 Kgs

Mounting

Omnimount 50WA

Omnimount 75WA

EMC Warning

It is inherent in the design of a loudspeaker and in the design of guitar pickups that they should emit or be affected by electro magnetic fields. Trace Elliot loudspeaker enclosures
should not be used less than 2 metres away from equipment which is likely to be affected by electro magnetic interference. Likewise, guitars fitted with electro magnetic pickups should
not be used less than 2 metres away from any source of electro magnetic emissions such as loudspeakers. Emissions from loudspeakers are dependent on the frequency characteristic
of the drive unit. Levels were measured direct from the drivers of 30 dBuV. These levels are reduced to a safe level at a distance of 1.27 metres from the drivers.

Compatibilité électromagnétique - avertissement

La conception d’un haut-parleur et des pickups de guitare est telle qu’ils sont affectés par des champs électromagnétiques ou en émettent les enceintes de haut-parleur Trace Elllot ne
devraient pas étre utilisées à moins de 2 mètres de l’équipement susceptible d’être affecté par les parasites électromagnétiques. Les émissions en provenance de haut-parleurs
dépendent de la caractéristique fréquentielle de l’émetteur piloté. De même, les guitares équipées de pickups électromagnétiques ne devraient pas être utilisées à moins de 2 mètres de
toute source d’émissions électromagnétiques telles que des haut-parleurs. Les niveaux ont été mesurés directement à partir des drivers de 30 dBuV. Ces niveaux sont réduites à un
niveau sûr à une distance de 1,27 mètre des drivers.

Reviews: