INSTALLATION INSTRUCTIONS
PORTABLE WASHDOWN PUMP KIT
T10068 Portable Washdown Pump Kit
GENERAL SAFETY & USAGE INFORMATION
Do NOT spray nozzle at people or animals or hot engines as this could cause harm or damage.
Do NOT place the kit in high temperature area for extended period of time.
Do NOT submerse the pump in water.
Do NOT use in hazardous areas.
The portable washdown pump kit has an internal protection circuit and may shut down if continuous
spraying of water exceeds 30 minutes.
After using the pump each time, disconnect the water inlet and outlet hoses.
SPECIFICATIONS
Pressure: 100 PSI Maximum
Voltage: 12V DC
Power: 170W
Maximum Inlet Water Temperature: 104◦F / 40◦C
APPLICATIONS
The TRAC® Portable Washdown Kit can be used to clean boats and boat decks, fish cleaning stations, docks and
RVs. It is easy to use for many cleaning or watering needs. The adjustable nozzle offers many applications:
Spray mist or sprinkler to water plants and grass. The spray height can reach over 13 ft (4m).
Spray jet to clean cars or RVs. It can be used to clean concrete, decks, even exterior walls and windows of
homes. The spray height can reach nearly 20 ft (6m).
The inlet water hose with filter can also be used to drain fish tanks or hot tubs.
The garden hose adaptor can be used to connect the inlet hose to a spigot.
STANDARD ACCESSORIES
One outlet hose, 19.7 ft (6m) with quick-connect fitting.
One adjustable spray nozzle with a plastic handle and brass spray nozzle.
One inlet hose, 6.6 ft (2m), with a filter and garden hose adaptor.
Battery Clip adaptor to connect to battery posts if 12v power port is not available.
OPERATION INSTRUCTIONS
Remove the contents from the shipping carton and take out the portable washdown kit to determine that all
pieces are included and undamaged. Read these instructions, then connect the water hoses and use it safely.
1.
Connect the inlet hose (BLUE hose with filter on one end) to the inlet quick-connect fitting on pump
housing. NOTE: quick-connectors can be pressed together to connect. To release, slide the outer
collar back and disconnect.
2.
Connect the outlet hose (BLACK hose) to the quick-connect fitting.
3.
Connect the power plug to any cigarette lighter style power port or use the battery clip adaptor to
connect directly to battery posts (red clip to battery positive and black clip to battery negative).
4.
Turn power switch ON.
NOTE: The pump does not run until the spray nozzle is pressed to spray water.
This is an ON-DEMAND pump. Meaning the pump only runs when water is being sprayed.
5.
Adjust the shape of the spray nozzle to achieve the desired spray pattern.
6.
When finished spraying, disconnect both water hoses, coil and store in housing. Secure coils with
included Velcro straps.
7.
Clean filter at end of inlet hose as needed. A second filter is located on side of pump housing inside the
hose compartment. To access the pump filter, remove the side panel to the hose compartment by lifting
it to release the hooks at the top corners. Tilt panel out and remove. A metal wrench is included to
remove clear filter cover by turning the clear cover counter-clockwise. Carefully remove filter and clean
with soft brush. Reassemble.
8.
To use the garden hose fitting, remove the inlet filter from inlet hose. Insert garden hose fitting.
Attach to spigot.
