TR-Electronic encoTRive MP Series, Safety Manual

Page: 24 / 35

General technical data and installation instructions

TR-Electronic GmbH 2022, All Rights Reserved Printed in the Federal Republic of Germany
Page 24 of 35 TR-EMO-BA-GB-0023 v00 04/20/2022
5.6 Mechanical
Storage and transport temperature .................................... -
20…+50 °C
Ambient temperature in operation ......................................
(variant-dependent) See product data sheet for respective article number
Relative humidity ................................................................
(non-condensing)
≤ 90 %

Protection class ................................................................
(variant-dependent)
See product data sheet for respective article number
Vibration ............................................................................ DIN EN 60068-2-6
MP-
060…MP-180 .......................................................
5 g
MP-200 ....................................................................... 10 g
Sine ............................................................................
50…2000 Hz, 60 min
Shock ................................................................................. DIN EN 60068-2-29
Acceleration ................................................................ 25 g / 6 ms
Shocks per axis .......................................................... 1000
5.7 Connection instructions
●
Risk of damage to the encoTRive drive system due to incorrect instal-
lation work!

Make sure that the plug connectors are not damaged during installa-
tion. Bent pins can destroy the drive due to short-circuits.
 All plug connectors should only be fitted “hand-tight”.

Connection cables must be laid so that damage during operation, e.g.
due to chafing, squeezing or bending, can be excluded.

Tensile stress on cables must be avoided.
The connection configuration can be found in the customer-specific pin assignment.

MP-200 with gear
The protection class with gears PLE60, PLE80, WPLE60 or WPLE80
(or with comparable gears) is IP54, unless specified otherwise in the product data sheet
MP-200 without gear
The housing protection class is IP54, unless specified otherwise in the product data sheet,
the shaft protection class is IP41
MP-
060…180
The protection class is IP40