Basic safety instructions
Printed in the Federal Republic of Germany
TR-Electronic GmbH 2012, All Rights Reserved
11/15/2012
TR - ECE - BA - DGB - 0091 - 02
Page 47 of 68
2.9 Safety information's
Destruction, damage or malfunctions of the measuring system and
risk of physical injury!
De-energize the system before carrying out wiring work or opening and
closing electrical connections.
Do not carry out welding if the measuring system has already been
wired up or is switched on.
Ensure that the area around the assembly site is protected from
corrosive media (acid, etc.).
Avoid any shocks (e.g. hammer-blow) on the shaft while mounting.
Do not open the measuring system.
The measuring system contains electrostatically endangered circuit
elements and units which can be destroyed by an improper use.
Contacts of the measuring system connection contacts with the fingers
are to be avoided, or the appropriate ESD protective measures are to
be applied.
Disposal
If disposal has to be undertaken after the life span of the device, the
respective applicable country-specific regulations are to be observed.