User's Guide l MBox-R/V/VH-E39 UG 0100 l © 2021 TQ-Group
Page 1
1.
IMPORTANT INFORMATION
1.1
General
Be sure to follow the tips given in this User's Guide to make best use of the MBox-R/-V/-VH-E39.
Failure to do so might lead to discomfort or injury, or cause the MBox-R/-V/-VH-E39 to fail.
1.2
Symbols and Typographic Conventions
Table 1:
Terms and Conventions
Symbol
Meaning
This symbol represents the handling of electrostatic-sensitive modules and / or components. These
components are often damaged / destroyed by the transmission of a voltage higher than about 50 V.
A human body usually only experiences electrostatic discharges above approximately 3,000 V.
This symbol indicates the possible use of voltages higher than 24 V.
Please note the relevant statutory regulations in this regard.
Non-compliance with these regulations can lead to serious damage to your health and also cause
damage / destruction of the component.
This symbol indicates a possible source of danger. Acting against the procedure described can lead to
possible damage to your health and / or cause damage / destruction of the material used.
This symbol represents important details or aspects for working with TQ-products.
1.3
Before You Start
This User's Guide must be carefully read and completely understood before you start working with the MBox-R/-V/-VH-E39.
This User's Guide provides information, which is essential for proper operation of the MBox-R/-V/-VH-E39. General safety
instructions must be adhered to and only trained and authorized personnel is permitted to work with the MBox-R/-V/-VH-E39.
1.4
Duty Of Care
It must be ensured that the MBox-R/-V/-VH-E39 is only used in environments, which meet the specification of the MBox-R/-V/-
VH-E39. The User's Guide has to be completely read and understood and the personnel is authorized and trained regarding
standards, regulations and instructions. It also has to be ensured, that the MBox-R/-V/-VH-E39 is mounted, operated and
maintained according to the instruction of this User's Guide. All applicable national and international regulations and standards
have to be obeyed.
1.5
Limited Warranty
Parts which wear out naturally are excluded from the warranty beyond that provided by law.
This applies to e.g., coin cell batteries.
1.6
Liability and Warranty Obligation
TQ-Systems GmbH shall be exempted from the statutory accident liability obligation in case the user does not observe the
information provided in this User's Guide or the warnings on the device. In the event of damage caused by failure to observe
the information provided in this User's Guide or the warnings on the device, TQ-Systems GmbH shall not be required to honour
the warranty even during the warranty period and shall be exempted from the statutory accident liability obligation.
