Sharedband Bonded Broadband
TP-Link W8968 Flashing Guide
Introduction
This document is to instruct you how to install the Sharedband firmware on a TP-Link W8968
Note: This guide assumes that the TP-Link has stock firmware Installed.
Preparation
Make sure you have the current Sharedband Firmware (Available from the NOC or the Support
Team).
The Procedure
Step 1:
Throw the TP-Link
CD in the Bin as this is no longer needed, and remove the “Run CD
First” Label from the LAN Ports
Step 2:
Ensure that your PC/Laptop has a static IP of 192.168.1.10
Step 3:
Ensure the power button is OFF and plug the router in to the mains.
Step 4:
Using a pin, depress the reset button. Keeping the reset button depressed, turn on the
power. Ensure that the reset button is depressed for a minimum of 10 seconds.
Step 5:
Plug your PC/Laptop into one of the LAN ports on the router.
