Operation Mode
Configure the Router
Standard Wireless Router
Standard Wireless Router
Access Point
Repeater
Client
To share a wired (Ethernet) connection to wireless devices, when in a
hotel room, small office and so on.
To transform an existing wired (Ethernet) network to a wireless one.
To extend the range of an existing Wi-Fi network.
To enable your wired device (such as Blu-ray® players, smart TVs, or
game consoles) to connect to a Wi-Fi network.
Operation Modes
Application
Access Point
1
Switch the Operation Mode to
Router/AP
and connect the hardware
according to Step
A
to
C
in the left diagram.
2
Connect your device to the router wirelessly or via an Ethernet
cable. The
SSID (Network Name)
and
Wireless password
are on the
router’s label.
3
Launch a web browser and type
http://tplinkwi
fi.net
in the address
bar. Enter
admin
(in lowercase) for both username and password to
log in.
4
Click
Next
to start the Quick Setup. Select
Standard Wireless
Router
and click
Next
.
5
Select the
WAN Connection Type
and follow the instructions. When
using the router in a hotel room or a small office, select
Dynamic IP
.
Note: If the router is successfully connected to internet, this step will be skipped.
6
On the
Wireless
page, either customize your
Wireless Network
Name
and
Wireless Password
or keep the default ones, and then
click
Next
.
7
Click
Finish
to complete the configuration.
1
Switch the Operation Mode to
Router/AP
and connect the hardware
according to Step
A
to
C
in the left diagram.
2
Connect your device to the router wirelessly or via an Ethernet
cable. The
SSID (Network Name)
and
Wireless password
are on the
router’s label.
3
Launch a web browser and type
http://tplinkwi
fi.net
in the address
bar.
Enter
admin
(in lowercase) for both username and password to
log in.
4
Click
Next
to start the Quick Setup. Select
Access Point
and click
Next
.
5
Either customize your
Wireless Network Name
and
Wireless
Password
or keep the default ones, and then click
Next
.
6
Select the LAN IP type of the router or leave the default setting
Smart IP
for most cases, and then click
Next
.
7
Click
Reboot
to complete the configuration.
7106506715 REV3.0.0
*TL-WR810N (European version) is used
for demonstration in this QIG.
300Mbps Wi-Fi Pocket Router/AP/
TV Adapter/Repeater
LAN/WAN
Internet
B
C
A
LAN
OR
Internet
Wired Router
C
LAN/WAN
B
A
Mode Switch
Install the plug and choose the operation mode of the router as needed.
Quick Installation Guide
