35
Chapter 4
Configure the Access Point
3. A success message will appear on the WPS page if the client device has been successfully
added to the access point’s network.
Method Three: Enter the Access Point’s PIN
1. Keep the WPS Status as
Enabled
and get the
Current PIN
of the access point.
2. Enter the access point’s current PIN on your client device to join the access point’s Wi-Fi
network.
4. 4. 4. Wireless MAC Filtering
Wireless MAC Filtering is used to deny or allow specific wireless client devices to access
your network by their MAC addresses. This function is not available when the operation
is set to Client. As the configuration is the same in each operation mode, here we just
take the Access Point for example.
Deny or allow specific wireless client devices to access my network by their MAC
addresses.
For example
, you want the wireless client A with the MAC address 00-0A-EB-B0-00-
0B and the wireless client B with the MAC address 00-0A-EB-00-07-5F to access the
access point, but other wireless clients cannot access the access point.
1. Visit
, and log in using the password you created.
2. Go to
Wireless
>
Wireless MAC Filtering
.
3. Click
Enable
to enable the Wireless MAC Filtering function.
I want to:
