44
Chapter 4
Configure the Access Point
1 ) Enter the MAC address 00-0A-EB-B0-00-0B/00-0A-EB-
00-07-5F in the MAC Address field.
2 ) Enter wireless client A/B in the Description field.
3 ) Select
Enabled
in the Status drop-down list.
4 ) Click
Save
and click
Back
.
7. The configured filtering rules should be listed as the picture
shows below.
Now only client A and client B can access your network.
4. 4. 4. Wireless Advanced
The configuration for each operation mode is almost the same, we take Access Point
mode for example here.
1. Visit
, and log in using
admin
(all lowercase) for both username and password.
2. Go to
Wireless
>
Wireless Advanced
.
3. Configure the advanced settings of your wireless network and click
Save
.
Note:
If you are not familiar with the setting items on this page, it’s strongly recommended to keep the provided default values;
otherwise it may result in lower wireless network performance.
Done!
Downloaded from
