Configuring LAG
Configuration Example
Configuration Guide
119
3.3 Using the GUI
The configurations of Switch A and Switch B are similar. The following introductions take
Switch A as an example.
1) Choose the menu
Switching > LAG > LAG Table
to load the following page. Select the
hash algorithm as ‘SRC MAC+DST MAC’.
Figure 3-2
Global Configuration
2) Choose the menu
Switching > LAG > LACP Config
to load the following page. In the
Global Config
section, specify the system priority of Switch A as
0
and Click
Apply
.
Remember to ensure that the system priority value of Switch B is bigger than 0.
Figure 3-3
System Priority Configuration
3) In the
LACP Config
section, select ports 1/0/1-10, and respectively set the admin key,
port priority, mode and status for each port as follows. Click
Apply
.
