Ethernet Cable
Extender
TL-WPA7510
Adapter
TL-PA7010
Pow
erline
Router
1
Internet
1000Mbps
LAN
On
2
Plug in the adapter and extender in the
same room. Wait for about 30 seconds
until the extender’s 2.4GHz and 5GHz
Wi-Fi LEDs turn on.
Note:
If only one wall outlet is available, plug both
devices into a power strip for setup, then relocate
to wall outlets before enjoying the internet.
1000Mbps
* TL-WPA7510 KIT (European version) is
used for demonstration in this QIG.
Pair the powerline devices.
4
3
Note:
If the Powerline LED turns red, it means the signal strength is poor. Try another wall outlet.
Relocate the extender to the Wi-Fi “dead” zone on the same electrical circuit. Connect your devices
to the internet using the default SSID (network name) and password on the Wi-Fi Info Card provided.
Tips:
Want to unify Wi-Fi networks or
personalize your network?
See the back page for instructions.
Attention
Wall Outlet
Power Strip
Plug powerline devices into wall outlets. Do not use power strips after setup.
Note:
If the LED does not blink, press the
button again.
Press the adapter‘s Pair button for 1 second.
The Power LED starts blinking.
A
Within 2 minutes, press the extender’s Pair button for 1 second.
The Power LED starts blinking.
B
When the Powerline LED turns on, the pairing process is
complete.
Extender TL-WPA7510
Within 2 minutes
Adapter TL-PA7010
1000Mbps
Pair
LED
W
i-Fi
Reset
Pair
1000M
bps
Blinking
Blinking
On
Quick Installation Guide
TL-WPA7510 KIT
