Configuring Maintenance
System Log Configurations
Configuration Guide
705
3.1 Using the GUI
3.1.1 Configuring the Local Log
Choose the menu
Maintenance > Log> Local Log
to load the following page.
Figure 3-1
Configuring the Local Log
Follow these steps to configure the local log:
1) Select your desired channel and configure the corresponding severity and status.
Channel
Local log includes 2 channels: log buffer and log file.
Log buffer indicates the RAM for saving system log. The channel is enabled by
default. The information in the log buffer is displayed on the
Maintenance > Log>
Log Table
page. It will be lost when the switch is restarted.
Log File indicates the flash sector for saving system log. The information in the
log file will not be lost after the switch is restarted and can be exported on the
Maintenance > Log >
Backup Log
page.
Severity
Specify the severity level of the log information that is saved to the selected
channel. Only the log with the same or smaller severity level value can be saved.
There are 8 severity levels marked from 0 to 7. The smaller value means the
higher priority.
Status
Enable or disable the channel.
Sync-Periodic
By default, the log information is saved in the log buffer immediately, and
synchronized to the log file every 24 hours. If necessary, you can modify the log
synchronization frequency using the CLI.
2) Click
Apply
.
Summary of Contents for T2500G-10MPS
Page 1: ...User Guide T2500G 10MPS 1910012405 REV1 0 1 April 2018...
Page 24: ...Using the CLI 767 Appendix Default Parameters 773...
Page 145: ...Part 5 Monitoring Traffic CHAPTERS 1 Traffic Monitor 2 Appendix Default Parameters...
Page 172: ...Part 7 Configuring DDM CHAPTERS 1 Overview 2 DDM Configuration 3 Appendix Default Parameters...
