Configuration Guide
216
Configuring Protocol VLAN
Protocol VLAN Configuration
2.2.3 Configuring Protocol VLAN
Follow these steps to configure protocol VLAN:
Step 1
configure
Enter global configuration mode.
Step 2
show protocol-vlan template
Check the index of each protocol template.
Step 3
protocol-vlan vlan
vid
template
index
Bind the protocol template to the VLAN.
vid
: ID of the 802.1Q VLAN where the port with protocol VLAN enabled is.
index
: Protocol template index.
Step 4
interface { fastEthernet
port
| range fastEthernet
port-list
|
gigabitEthernet
port
| range
gigabitEthernet
port-list
| ten-gigabitEthernet
port
| range ten-gigabitEthernet
port-list
}
Enter interface configuration mode.
Step 5
show protocol-vlan vlan
Check the protocol VLAN index (entry-id) of each protocol group.
Step 6
protocol-vlan group
entry-id
Add the specified port to the protocol group.
entry-id:
Protocol VLAN index.
Step 7
end
Return to Privileged EXEC Mode.
Step 8
copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to bind the IPv6 protocol template to VLAN 10:
Switch#configure
Switch(config)#show protocol-vlan template
Index Protocol Name Protocol Type
-------- ------------------ --------------------------------
1 IP EthernetII ether-type 0800
2 ARP EthernetII ether-type 0806
3 RARP EthernetII ether-type 8035
4 IPX SNAP ether-type 8137
Summary of Contents for T2500G-10MPS
Page 1: ...User Guide T2500G 10MPS 1910012405 REV1 0 1 April 2018...
Page 24: ...Using the CLI 767 Appendix Default Parameters 773...
Page 145: ...Part 5 Monitoring Traffic CHAPTERS 1 Traffic Monitor 2 Appendix Default Parameters...
Page 172: ...Part 7 Configuring DDM CHAPTERS 1 Overview 2 DDM Configuration 3 Appendix Default Parameters...
