52
Syntax
user access-control
ip-based
{
ip-addr ip-mask
}
[ snmp ] [ telnet ] [ ssh ]
[ http ] [ https ] [ ping ] [ all ]
no user access-control
[
ip-based index
id
]
Parameter
ip-addr
—— The source IP address. Only the users within the IP-range you
set here are allowed to access the switch.
ip-mask
——The subnet mask of the IP address.
[ snmp ] [ telnet ] [ ssh ] [ http ] [ https ] [ ping ] [ all ] —— Specify the access
interface. These interfaces are enabled by default.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Enable the access-control of the user whose IP address is 192.168.0.148:
T1600G-52TS(config)# user access-control ip-based
192.168.0.148
255.255.255.255
8.4
user access-control mac-based
Description
The
user access-control mac-based
command is used to limit the MAC
address of the users’ access. Only the user with this MAC address you set
here is allowed to access the switch. To cancel the user access limit, please
use
no user access-control
command.
Syntax
user access-control
mac-based
{
mac-addr
}
[ snmp ] [ telnet ] [ ssh ] [ http ]
[ https ] [ ping ] [ all ]
no user access-control
Summary of Contents for T1600-28TS
Page 1: ...CLI Reference Guide T1600G Series Switches REV2 0 0 1910011957...
Page 57: ...41 T1600G 52TS config show voice vlan switchport gigabitEthernet 1 0 2...
Page 64: ...48 Example Display the LACP system priority T1600G 52TS config show lacp sys id...
Page 365: ...349 Example Display the configuration of DHCP Relay T1600G 52TS config show ip dhcp relay...
