PW-AN401/PW-AN401D
150M Wireless N Access Point User Guide
29
)
Note:
The default PIN code of the AP can be found in its label or the WPS configuration screen as Figure
4-5 .
You will see the following screen when the wireless adapter has successfully connected to the AP.
)
Note:
1. The WPS LED on the AP will light green for five minutes if the device has been successfully
added to the network.
2.
The WPS function cannot be configured if the Wireless function of the AP is disabled. Please
make sure the Wireless function is enabled before configuring the WPS.
4.6 Network
The
Network
option allows you to customize your local network manually by changing the default
settings of the AP.
Selecting
Network
will enable you to configure the IP parameters of Network on this page.
Figure 4-8 Network
¾
MAC Address
-
The physical address of the AP. The value can't be changed.
¾
configure IP address manually from the drop-down list.
¾
IP Address -
Enter the IP address of your AP in dotted-decimal notation (factory default
setting is 192.168.0.254).
