(over)
Mounting Instructions Wall Hung Bracket for model HC-190
Included with the Wall Hung Bracket are 4 #10
by 1/2
”
self-tapping screws and 4 #12 by
1 ¼”
screws with 4 white plastic Toggle
™
anchors
and one red plastic key.
First find a location on the wall where all
necessary plumbing and electric connections
can be made. On the Wall Hung Bracket there
are 4 screw holes for
mounting to the wall.
(See arrows in Photo 1.) They are
located 16 inches apart. All 4 screw holes must be
used to anchor the Heat Convector to the wall.
*Wall Hung Bracket is not recommended for sheetrock or other materials
less than 3/8”
thick.
If the Wall Hung Bracket is to be mounted into studs then the Toggle
™
anchors are not needed.
If no stud is located behind the mounting location then Toggle
™ anchors
(included) are needed.
Hold Wall Hung Bracket to wall. Check that Wall Hung Bracket is level and mark holes to be drilled on
wall (see arrows above in Photo 1).
Follow steps for Toggle™ anchors below.
1-Drill a 5/16" diameter hole. Fold anchor in middle.
2-Insert anchor in hole and tap flush.
3-Insert red plastic key to pop anchor open behind hollow wall (not
necessary for thick or solid walls). Do not hammer key. Remove key.
Photo 1