Toyota Tundra 2015, Manual

Page: 221 / 576

221
4-5. Using the driving support systems
4
Dr
ivi
n
g
■
The Blind Spot Monitor function is operational when
●
The BSM main switch is set to on.
●
Vehicle speed is greater than approximately 25 mph (40 km/h).
■
The Blind Spot Monitor function will detect a vehicle when
●
A vehicle in an adjacent lane overtakes the vehicle.
●
Another vehicle enters the detection area when it changes lanes.
■
Conditions under which the Blind Spot Monitor function will not detect a
vehicle
The Blind Spot Monitor function is not designed to detect the following types
of vehicles and/or objects:
●
Small motorcycles, bicycles, pedestrians, etc.
*
●
Vehicles traveling in the opposite direction
●
Guardrails, walls, signs, parked vehicles and similar stationary objects
*
●
Following vehicles that are in the same lane
*
●
Vehicles driving 2 lanes across from your vehicle
*
*
: Depending on conditions, detection of a vehicle and/or object may occur
■
Conditions under which the Blind Spot Monitor function may not func-
tion correctly
●
The Blind Spot Monitor function may not detect vehicles correctly in the fol-
lowing conditions:
• During bad weather such as heavy rain, fog, snow, etc.
• When ice or mud, etc., is attached to the rear bumper
• When driving on a road surface that is wet due to rain, standing water,
etc.
• When there is a significant difference in speed between your vehicle and
the vehicle that enters the detection area
• When a vehicle is in the detection area from a stop and remains in the
detection area as your vehicle accelerates
• When driving up or down consecutive steep inclines, such as hills, a dip
in the road, etc.
• When multiple vehicles approach with only a small gap between each
vehicle
• When vehicle lanes are wide, and the vehicle in the next lane is too far
away from your vehicle
• When the vehicle that enters the detection area is traveling at about the
same speed as your vehicle
• When towing anything such as trailer, boat, etc.
• When there is a significant difference in height between your vehicle and
the vehicle that enters the detection area
• Directly after the BSM main switch is set to on
• When towing a trailer
• When items such as a bicycle carrier are installed on the rear of the vehi-
cle