Toyota Prius 2018, Owner'S Manual, Page: 686 / 820

686
8-2. Steps to take in an emergency
PRIUS_OM_OM47B89U_(U)
■
Warning messages
The warning messages explained below may differ from the actual messages
according to operation conditions and vehicle specifications.
■
System warning lights
The master warning light does not come on or flash in the following cases.
Instead, a separate system warning light will come on along with a message
or image shown on the multi-information display.
●
“Antilock Brake System Malfunction Visit Your Dealer”:
The ABS warning light comes on. (
→
P. 674)
●
“Braking Power Low Visit Your Dealer”:
The brake system warning light (yellow) will come on. (
→
P. 673)
●
Indicates that a door is not fully closed while the vehicle is stopped.:
The Open door warning light comes on. (
→
P. 675)
■
If “Visit Your Dealer” is shown
The system or part shown on the multi-information display is malfunctioning.
Have the vehicle inspected by your Toyota dealer.
■
If a message about an operation is shown
●
If a message about an operation of the accelerator pedal or brake pedal is
shown
A warning message about an operation of the brake pedal may be shown
while the driving assist systems such as PCS (Pre-Collision System) (if
equipped) or the dynamic radar cruise control with full-speed range (if
equipped) is operating. If a warning message is shown, be sure to deceler-
ate the vehicle or follow an instruction shown on the multi-information dis-
play.
●
A warning message is shown when Drive-Start Control or Intelligent Clear-
ance Sonar (if equipped) operates (
→
P. 216, 356). Follow the instructions
on the multi-information display.
●
If a message about an operation of the power switch is shown
An instruction for operation of the power switch is shown when the incorrect
procedure for starting the hybrid system is performed or the power switch is
operated incorrectly. Follow the instructions shown on the multi-information
display to operate the power switch again.
●
If a message about a shift operation is shown
To prevent the shift position from being selected incorrectly or the vehicle
from moving unexpectedly, the shift position may be changed automatically
(
→
P. 242) or operating the shift lever or P position switch may be required.
In this case, change the shift position following the instructions on the multi-
information display.
●
If a message or image about an open/close state of a part or replenishment
of a consumable is shown
Confirm the part indicated by the multi-information display or a warning light,
and then perform the coping method such as closing the open door or
replenishing a consumable.