Toyota Land Cruiser Prado 2013, Owner'S Manual, Page: 582 / 736

583
7-3. Do-it-yourself maintenance
LC150_OM_OM60K29E_(EE)
 LED lights
The headlight low beams (LED headlights), front position lights/daytime run-
ning lights (LED headlights), side turn signal lights, high mounted stoplight,
stop/tail lights consist of a number of LEDs. If any of the LEDs burn out, take
your vehicle to any authorized Toyota dealer or repairer, or another duly qual-
ified and equipped professional to have the light replaced.
 Condensation build-up on the inside of the lens
Temporary condensation build-up on the inside of the headlight lens does not
indicate a malfunction. Contact any authorized Toyota dealer or repairer, or
another duly qualified and equipped professional for more information in the
following situations:
 Large drops of water are built up on the inside of the lens.
 Water has built up inside the headlight.
CAUTION
 Replacing light bulbs

Turn off the headlights. Do not attempt to replace the bulb immediately
after turning off the headlights.
The bulbs become very hot and may cause burns.

Do not touch the glass portion of the light bulb with bare hands. When it is
unavoidable to hold the glass portion, use and hold with a clean dry cloth
to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
 Fully install light bulbs and any parts used to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
 Do not attempt to repair or disassemble light bulbs, connectors, electric
circuits or component parts.
Doing so may result in death or serious injury due to electric shock.
 To prevent damage or fire

Make sure bulbs are fully seated and locked.

Check the wattage of the bulb before installing to prevent heat damage.