Toyota 1RZ, Supplement Manual

Page: 346 / 525

17. CYLINDER BORING EM-74/75
18. INSPECT CRANKSHAFT FOR RUNOUT EM-75
19. INSPECT MAIN JOURNALS AND CRANK PINS EM-75/76
20. IF NECESSARY, GRIND AND HONE MAIN JOURNALS AND/OR CRANK PINS EM-76
REASSEMBLY
1. REPLACE CRANKSHAFT FRONT OIL SEAL
EM-77
2. REPLACE CRANKSHAFT REAR OIL SEAL EM-77
3. ASSEMBLE PISTON AND CONNECTING ROD EM-78
4. INSTALL PISTON RINGS EM-78
5. INSTALL BEARINGS EM-78
6. INSTALL MAIN BEARINGS EM-79
7. INSTALL UPPER THRUST WASHERS EM-79
8. PLACE CRANKSHAFT ON CYLINDER BLOCK EM-79
9. PLACE MAIN BEARING CAPS AND LOWER THRUST WASHERS ON CYLINDER
BLOCK EM-79/80
10. INSTALL MAIN BEARING CAP BOLTS EM-80
11. INSTALL PISTON AND CONNECTING ROD ASSEMBLIES EM-80
12. PLACE CONNECTING ROD CAP ON CONNECTING ROD EM-80
13. INSTALL CONNECTING ROD CAP NUTS EM-81
14. INSTALL REAR OIL SEAL RETAINER EM-81/82
15. INSTALL CRANKSHAFT POSITION SENSOR CONNECTOR BRACKET EM-82
16. INSTALL ENGINE WIRE BRACKET EM-82
17. INSTALL RH AND LH ENGINE MOUNTING EM-82
18. INSTALL OIL PRESSURE SWITCH EM-82
19. INSTALL ENGINE COOLANT DRAIN COCK EM-82
20. OIL FILTER BRACKET EM-82
21. INSTALL OIL FILTER EM-82
22. INSTALL WATER BYPASS PIPE EM-82
23. INSTALL KNOCK SENSOR EM-82
24. INSTALL TIMING CHAINS, GEARS AND SPROCKETS EM-83
25. INSTALL CYLINDER HEAD EM-83
26. REMOVE ENGINE STAND EM-83
27. INSTALL REAR END PLATE EM-83
28. INSTALL FLYWHEEL EM-83
PAGE 2 OF 2
CLICK HERE TO VIEW CHAPTER INDEX
TO MODEL INDEX
ENGINE MECHANICAL – CYLINDER BLOCK (2RZ-FE, 3RZ-F)
Pages From Supplement
3RZ-F,3RZ-FE