TOWNGAS Mia Cucina CUBE 900, Instruction On Installation And Use, Page: 6 / 18

Maintenance
ATTENTION!
Before performing any maintenance
operation, isolate the hood from the electrical
supply by switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected through
a plug and socket, then the plug must be
removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at
least with the same frequency with which you carry
out maintenance of the grease filter) internally and
externally. Clean using the cloth dampened with
neutral liquid detergent. Do not use abrasive
products.
DO NOT USE ALCOHOL!
WARNING:
Failure to carry out the basic cleaning
recommendations of the cooker hood and the
filters may cause fire risks.
Therefore, we recommend observing these
instructions.
The manufacturer declines all responsibility for any
damage to the motor or any fire damage linked to
inappropriate maintenance or failure to observe
the above safety recommendations.
Grease filter
Fig. 11
This must be cleaned once a month (or when the
filter saturation signal is indicated) using non
aggressive detergents, either by hand or in the
dishwasher, which must be set to a low tempera-
ture and a short cycle.
When washed in a dishwasher, the grease filter
may discolour slightly, but this does not affect its
filtering capacity.
To remove the grease filter, pull the spring
release handle.
Functioning
1. Motor OFF button
2. ON button and motor speed selection button
1 - 2 - 3 - 1 - 2 - . . . .
3. Speed 1 LED
4. Speed 2 LED and metal grease filter
saturation LED (in this latter case, the LED
will flash - See instructions on grease filter
cleaning).
Once the grease filters have been cleaned,
press button 1 for about 3 seconds until you
hear the acoustic signal (beep): the LED 4 will
now stop flashing.
5. Speed 3 LED and active carbon filter
saturation LED (in this latter case, the LED
will flash - See instructions on active carbon
filter replacement).
Once you have replaced the charcoal filter,
press button 1 for about 3 seconds until you
hear the acoustic signal (beep). LED 5 will
now stop flashing.
Warning!
The active carbon filter saturation LED is not
activated.
In order to activate the active carbon filter
saturation indicator, press buttons 2 and 7
simultaneously for 3 seconds. Initially, only
LED 4 will flash, then after the 3 seconds
have passed, LED 5 will also start flashing,
indicating that the active carbon filter
saturation control system is active.
To switch off the system, re-press the same
two buttons: after 3 seconds LED 5 will stop
flashing and the device will be switched off.
6. Intensive speed LED
7. Intensive speed ON switch
This speed should be used when the concen-
tration of cooking fumes or odours is
particularly strong (for example when frying,
cooking fish etc.).
The fast speed will run for about 5 minutes
and then return to the speed previously set
automatically (1, 2 or 3), or switch off if no
speed was selected.
To turn off the fast speed, before the end of
the 5 minutes, press button 1 or button 2.
8. OFF lamp button
9. ON lamp button
If the hood fails to operate correctly, briefly
disconnect it from the mains power supply for
about 5 sec. by pulling out the plug. Then plug it
in again and try once more before calling for
service.
4
1 2 3
4
5
6 7
8 9