❍
3. Turn on the transmitter using the switch on the front. The red
LED light next to the on/off switch should light up. If the LED does
not light up, turn off the transmitter and check to make sure that the
batteries are installed properly. If you see a flashing LED, the batteries
are low and need to be replaced.
❍
1. Remove the body pin toward the rear of the hatch cover and
carefully remove the hatch.
❍
2. Using a small Phillips screwdriver, remove the two 1.6 x 17mm
screws and
carefully
lift the radio box cover.
❍
3. Uncoil the receiver antenna wire and route it through the small
hole in the rear wall of the radio box. Replace the radio box cover
and secure it with the two 1.6 x 17mm screws.
❍
4. Run the receiver antenna wire up through the antenna tube
mount (the small opening located toward the rear of the hatch).
❍
5. Thread the receiver antenna wire through the antenna tube and
insert the antenna tube into the antenna tube mount.
DO NOT CUT
OFF THE EXCESS ANTENNA WIRE!
❍
1. Plug a fully charged battery pack into the speed control’s battery
connector and position the pack as shown in the photo.
Use the
included hook and loop material to hold the battery pack in place.
❍
2. Turn on the transmitter and then, move the boat’s ON/OFF
switch to the “ON” position.
Installation of the Battery Pack
Receiver Antenna
3
