- 8 -
tousek
/ EN_ST-12-5_05 / 25. 03. 2020
Push buttons, key switches or external radio receivers with potential-free make contacts can be used as impulse
switches.
Warning
•
Before taking off the control cover,
the main switch must be turned off !
•
If an emergency battery is connected, also discon-
nect this battery!
•
The inside of the control unit is under tension when
power supplied.
•
In order to avoid electrical strokes, the safety regula-
tions have to be respected.
•
The device may only be connected by qualified
personnel (specialised staff).
•
The product is not suitable for installation in explosion-
hazardous/explosive areas.
•
An all-pole disconnecting main switch with a contact
opening gap of min. 3 mm has to be foreseen. The
gate facility has to be secured according to the valid
safety regulations!
•
IMPORTANT: The control lines (sensor, buttons, radio,
photocells, etc.) have to be laid separately from the
230V lines (supply line, motors, signal lamp)
.
• A general status display of all inputs is available in menu DIAGNOSIS/STATUS DISPLAY.
G
Impulse button
(terminals 30/32)
Buttons/switches
OPEN/STOP/CLOSE successive impulses (factory setting):
An impulse of the impulse switch makes the motor start opening/closing. If the impulse switch is actuated again during this
opening-/closing movement, the motor stops. With the next command of the impulse switch the motor moves in the opposite
direction of the last gate movement.
OPEN/CLOSE/OPEN successive impulses:
an impulse of the impulse switch makes the motor start opening/closing.
If the impulse switch is actuated again during this opening/closing movement, the travel direction is reversed.
•
In this operation mode it is not possible to stop the motor with the impulse switch – it always
moves until reaching an end position. (Opened or closed position).
• for the function OPEN/CLOSE/OPEN we strongly suggest the installation of a photocell!
OPEN:
Only opening commands are accepted by the impulse switch – closing the gate with the impulse switch is not
possible.
DEAD MAN:
The motor opens as long as the impulse switch is pressed (hold) – closing the gate with the impulse switch
is not possible. As soon as the switch is released, the motor stops. If dead man‘s operation (=hold to run) is chosen,
the radio receiver is out of order for reasons of safety
.
• If the impulse switch is set to DEAD MAN operation, then the pedestrian button works
the same way. With the impulse switch the gate is opened, with the pedestrian button it is closed.
• IMPORTANT: Do not put into operation in dead man mode.
Select only after putting into operation (see page 22), if desired.
Buttons/switches
Connections and adjustments
4. Connections and adjustments
Swing gate control unit ST 12/5
The single menu points are marked as shown below:
= possible adjustment (or value assignment)
= factory setting
= status display
G
marks the menu points which are contained in the BASIC SETTINGS.
