9
Replacing Angelina’s Camera Assembly
Setting the Camera’s White Balance
Setting the Camera’s White Balance
Now that you have installed and aligned the camera’s firmware, you must set the camera’s white balance to
optimize the coloration of its images.
1. Stand at arm’s length from the Angelina screen. This simulates the optimal distance a patron’s face would be
positioned from the camera.
2. From the Operator interface, go to
HARDWARE
>
Camera
and then press the
WHITE BALANCE
button.
The Preview screen will display a red square.
3. Hold up a stack of white or light gray paper and position it at a 45 degree angle backwards (that is, tilting the
top towards yourself). Do not use a single sheet of paper as it may be translucent. The entirety of the red
square should be filled on screen by your sheet and you should be reflecting the ceiling light towards the
camera.
Setting white balance
4.
The white balance process will take approximately 5 seconds. Keep the sheet as still as possible during this
time.
You have now completed the replacement of the camera assembly.
NOTE
If the location generally operates under low-lighting conditions, it is essential to
replicate these lighting conditions when performing the white balance
procedure.
NOTE
If the lighting of the location changes significantly and permanently, you should
reset the white balance as part of your routine when visiting the location.
