8
Replacing Angelina’s Camera Assembly
Aligning the Camera
Aligning the Camera
Before you proceed with the camera calibration, it is critical that the Angelina jukebox be mounted at the correct
height.
The top of the Angelina bracket should be 62 inches from the floor. The correct height is necessary to avoid
damage to the bracket and to achieve the correct calibration.
Wall bracket height
If your Angelina jukebox is not mounted at this height, consult the
Angelina Installation and Setup Guide
for
mounting instructions.
To properly align the camera, you must use the Video Capture Test utility on the Operator menu.
1. On the I/O Board, press the
MNGR
button to open the Operator menu.
2. From the main menu, select
HARDWARE
and then press the
Camera
button. The preview area displays the
field of view being captured by the camera.
3. If part of the image is obscured or presents a “tunnel vision” effect, you will have to adjust the position of the
camera.
4. Put a mark on the floor 152 inches away from the wall, centered with the Angelina jukebox.
5. Turn the screw in the middle of the camera bracket on the rear of the bracket until you see the mark on the
floor at the bottom of the preview area.
6. The camera lens and the aperture on the exterior of the Angelina jukebox door should align vertically more
and more as you adjust the camera screw using the method above.
