USING YOUR ARC PALM
Priming the atomizer head
Note: It is important to “prime” a new atomizer head before first
use. Failure to do so can cause the atomizer coil to overheat,
leading to an unpleasant taste and sometimes irreversible damage
to the atomizer head.
Remove the Slider CS Air tank from the arc Palm by unscrewing.
Invert the Slider CS Air tank and unscrew the base. Drip a few
drops of e-liquid on each of the four e-liquid inlets on the side
of the atomizer head, and into its central hole to fully wet the
wicking material.
Filling the tank
Press the button located on the side of the tank and slide in
the direction indicated by the arrow, once opened fill the tank,
leaving an air gap of approximately 2mm above the fluid to avoid
air locks or flooding. Once filled, slide the tank shut and the
button will depress, locking the tank.
Note: After priming a new atomizer head and filling the tank, it is
recommended to wait 5 minutes to ensure the atomizer head is
fully saturated.
Power on and off
Press the power button 5 times quickly to turn the arc Palm on.
To turn the device off, press the power button 5 times.
Vaping
Press and hold the power button as you inhale the vapour.
The LED will illuminate while the power button is held down to
vape.
Battery level indication
Approximately one second after the power button is released, the LED will relight to show
the battery’s approximate remaining charge as detailed in the table below.
Charging the battery
To charge the battery, connect the charge lead into the USB
port. The LED on the front of the arc Palm will glow red and
simultaneously flash 5 times in green when the charge lead is
first connected. Once charging, the LED will continue to glow
red until fully charged, at which point it will turn off.
Changing the atomizer head
To change the atomizer head in the Slider CS
Air tank, remove the tank from the arc Palm by
unscrewing. Invert the tank and unscrew the
base. Remove the atomizer head from the base by
unscrewing, and insert a new atomizer head. After
fitting a new atomizer head, remember that it will
need priming as described in the section “Priming
the atomizer head”.
Adjustment of airflow:
To adjust the airflow to your personal preference, rotate the airflow control ring located
at the bottom of the tank. The more area exposed behind the slots in the airflow ring, the
more open the air draw will be.
Power
Button
Power
button
Battery
LED
USB
port
USER MANUAL
CONGRATULATIONS
ON PURCHASING
YOUR TOTALLY WICKED
ARC PALM ELECTRONIC
CIGARETTE KIT
Battery Level
100%-60%
59%-30%
29%-10%
9%-0%
LED Colour
Green
Orange
Blue
Red
Tank
Tank
base
Atomizer
head
