17
RS232 Serial Cable
If you will be using the RS232 external control option, you will need to have an RS232 serial
cable to connect your PC to the Master Controller/Amplifier. The specific wiring needs of
this cable are determined by your specific setup. You will need a male DB9 (DE9) plug on
the end that connects to the Master Controller/Amplifier.
See the
RS232 Serial Control section for more information about the control codes used by
the system.
IR Emitters
This system has the ability to repeat IR signals from each speaker zone to control the
source devices. To carry the IR signal from the Master Controller/Amplifier to the actual
source device requires the use of IR emitters (not included). The IR emitters connect to the
Master Controller via a 3.5mm TS plug. If the emitters are not long enough, you can use
standard 3.5mm TS or TRS extension cables to increase their lengths.
The IR repeater function supports single-band IR signals only (those in the 38KHz range).
Summary of Contents for 14524
Page 1: ...1 ...
