RE V. 2.1
MEg a sta R 27
5 INSTALLATION
5.1 TRANSPORT
5.1.1 t
ransPort
Condition
The machine is delivered covered by protective material for packaging.
5.1.2 v
erifiCation
of
damages
oCCured
during
transPort
Visually check the machine status after removing it from shipping container.
To move the pallet to utilize means and lifting accessories suitable to the weight and comply with current legislation. The lifting
and handling must be performed by qualified personnel trained in this type of operations.
Pay due attention to avoid impacts and rollovers.
Protect the machine from the outside weather.
Any deformation of the visible parts indicate shock suffered by the machine during transport, which could affect normal operation.
5.2 STORAGE
The information contained in this section shall be observed during periods of temporary storage of the machine that may occur in the
following situations:
• Delayed installation of the machine, not immediately after the delivery
• Turning off the machine and its storage, waiting for a relocation
5.2.1 s
torage
features
• Allowed temperature range: 5 ° C to 35 ° C
• Range of Acceptable humidity: 30% to 80%
• Natural and / or artificial adequate lighting
• Adequate protection from the weather
• Space required sufficient to perform the lifting and transport safely and easily
• Flat horizontal surface with a capacity greater than the mass of the machine
• Space required sufficient to make all the routine maintenance and technical service
5.3 INSTALLATION
5.3.1 i
nstallation
area
features
Do not use the device in a dirty, wet or very humid place.
r
oom
requirements
For the normal-use of the machine, including the operations of loading and unloading, it is necessary to have a space directly proportional
and appropriate to the size of the objects to be machined. The installation site must have the floor horizontal, flat, stable, non-resilient,
and near a power outlet.
a
tmosPheriCal
agents
ProteCtion
The machine must be placed in a covered and protected from direct contact with atmospheric agents (enclosed).
w
orking
surfaCe
Prepare the horizontal supporting surface on which to place the machine knowing the mass of the machine. Also take into consideration
ancillary equipment (tables, etc.).
l
ighting
To carry out safe working and maintenance of the machine requires good lighting industrial grade for machining of medium accuracy
(approximately 300-600 lux).
ENG
Ch a P t ER 5: INsta L L at ION
