E6581580
2.2. RJ45 connector pin layout
.2. RJ45 connector pin layout
The EtherNet/IP™ card is equipped with two shielded RJ45 connectors. The shielding
is connected to the drive ground.
Use an STP (shielded twisted pair) Ethernet cable
The transmission speed is detected automatically by the card (10 Mbps or 100 Mbps).
The card can operate in half duplex or full duplex mode, whether connected to a hub or
a switch and regardless of the transmission speed (10 Mbps or 100 Mbps).
Pin Signal
1 TD+
2 TD-
3 RD+
4
5
6 RD-
7
8
* Fix a cable so that a communication connector may be not taken the weight of wire.
2.3. Example of connection to an EtherNet/IP™
Daisy chain and/or star topology
Notes
Provide strain relief so that the communication connector does not take the weight
of the cable.
Please connect this option to only the Modbus TCP communication line.
This option does not work when connected to the other communication lines.
For example, the RJ45 connector on the front of AS1/PS1 operation panel is for
RS485 communication. Do not connect the Modbus TCP communication line to the
RJ45 connector
8………………1
Port L
8………………1
Port R
Ethernet switch
PLC
- 7 -
