1-2
TLPB2 Service Manual Rev. 2.0
3. REPLACEMENT OF MECHANICAL PARTS
3-1. Lamp Assembly
Step
Figure
Explanation
1
Remove two screws (M2.6 x 8).
These screws are retained with split washers.
2
Remove the lamp cover.
3
Remove two screws that secure the lamp module (M2.6 x 8).
These screws are retained with split washers.
4
Lift the lamp module out of the projector.
Electronic parts are susceptible to static electricity and may easily be damaged, so do not forget to take proper
grounding treatment as required.
Many screws are used inside the unit. To prevent missing, dropping, etc. of the screws, always use a
magnetized screwdriver in servicing. Several kinds of screws are used and some of them need special
cautions. That is, take care of the tapping screws securing molded parts and fine pitch screws used to secure
metal parts. If they are used improperly, the screw holes will be easily damaged and the parts can not be fixed.
CAUTIONS BEFORE SERVICING
