Toshiba TLCS-870/C Series, Manual

Page: 134 / 205

Page 119
TMP86PM29BUG
10.3.8.2 High-Frequency Warm-Up Counter Mode
(SLOW1
→
SLOW2
→
NORMAL2
→
NORMAL1)
In this mode, the warm-up period time from a stop of the high-frequency clock fc to the oscillation sta-
bility is obtained. Before starting the timer, set SYSCR2<XEN> to 1 to oscillate the high-frequency clock.
When a match between the up-counter and the timer register (TTREG6, 5) value is detected after the timer
is started by setting TC6CR<TC6S> to 1, the counter is cleared by generating the INTTC6 interrupt
request. After stopping the timer in the INTTC6 interrupt service routine, clear SYSCR2<SYSCK> to 0 to
switch the system clock from the low-frequency to high-frequency, and then SYSCR2<XTEN> to 0 to
stop the low-frequency clock.
Table 10-9 Setting Time in High-Frequency Warm-Up Counter Mode
Minimum time Setting
(TTREG6, 5 = 0100H)
Maximum time Setting
(TTREG6, 5 = FF00H)
16
µ
s 4.08 ms
Example :After checking high-frequency clock oscillation stability with TC6 and 5, switching to the NORMAL1 mode
SET (SYSCR2).7 : SYSCR2<XEN>
←
1
LD (TC5CR), 63H : Sets TFF5=0, source clock fc, and 16-bit mode.
LD (TC6CR), 05H : Sets TFF6=0, and warm-up counter mode.
LD (TTREG5), 0F800H : Sets the warm-up time.
(The warm-up time depends on the oscillator characteristic.)
DI : IMF
←
0
SET (EIRH). 4 : Enables the INTTC6.
EI : IMF
←
1
SET (TC6CR).3 : Starts the TC6 and 5.
: :
PINTTC6: CLR (TC6CR).3 : Stops the TC6 and 5.
CLR (SYSCR2).5 : SYSCR2<SYSCK>
←
0
(Switches the system clock to the high-frequency clock.)
CLR (SYSCR2).6 : SYSCR2<XTEN>
←
0
(Stops the low-frequency clock.)
RETI
: :
VINTTC6: DW PINTTC6 : INTTC6 vector table