4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO18-33012B
4.12 SWING CUTTER (B-4205-QM-R)
4-72
4.12.3.2 Installing the Swing Cutter Module on the B-SX5T Series
Since the strip module is standard on the B-SX5T series, it is necessary to remove the rewinder guide plate, strip
sensor, etc. before installing the cutter module.
1)
Turn the power off and disconnect the power cord.
2)
When the printer is used in the batch or strip mode:
Remove the two black screws to detach the front plate.
NOTE: Retain the two black screws and front plate.
When the printer is used in the built-in rewinder mode:
Open the top cover, remove the two SMW-4x8 screws, and detach the rewinder guide plate from
the printer.
3) Remove the four B-4x5 screws from the side panel (L).
4) Open the top cover and remove the three P-4x8 screws that secure the side panel (L).
Front Plate
Black Screws
B-4x5 Screw
P-4x8 Screw
Top Cover
B-4x5 Screw
Side Panel (L)
Rewinder Guide Plate
SMW-4x8B Screw
SMW-4x8B Screw