Toshiba SureMark 4610 1NR, Hardware Manual

Page: 32 / 64

Figure 14. Installed WiFi interface with cable routing
Installing the fillers
The fillers are an important part of your integrated system. They securely position your printer
into position with the system unit and other peripherals.
Refer to the installation documentation for your system unit for complete instructions.
Wall (or 45-degree) mounting
Attention: Printer must be powered off. The following ESD handling procedure is
recommended: You should touch the metal on the printer frame with the back of your hand
before making contact with the printer. Also, see “Electrostatic discharge (ESD)” on page 55.
Follow these steps to wall (or 45-degree) mount the printer unit:
1. Turn off the power to the 4610.
2. Roll the bottom position selector (part of the low-paper sensor;
A
in Figure 15) to the
WALL position.
32
Hardware Guide for Model 1NR