Toshiba Strata CIX IP5000 Series, User Manual, Page: 70 / 216

Feature Operations
Call Forward
52
Strata CIX IP5000-series Telephone UG 04/09
Station Call Forward Procedures
Table 22 on Page 179 contains Call Forward Button sequences. You can do a Call
Forward function by entering the button sequence as described or by programming a
Programmable Feature Button to perform the sequence. See
“Programming Feature
Buttons” on page 116 to program a Programmable Feature Button.

To use the Call Forward button sequence

Follow the instructions in Table 24 on Page 184 , shown under the “Button
Sequence” heading. Some features require additional input, such as:
• Dest. Ext. or Telephone No. – Call Forward destination numbers can be
internal extension numbers or outside telephone numbers. If the destination is
an outside number, enter the access code used for dialing out (such as
9
) + the
telephone
#
. The CIX accepts destination numbers of up to 32 digits.
• Timer – Enter the number of seconds (08~60) your telephone should ring
before forwarding the call. (This is the Call Forward-No Answer timer.)
• Call Forward Pass Code – A four-digit Call Forward pass code can be setup
by your System Administrator and will allow one station to activate the call
forward setting for another station. Users must enter the Call Forward pass code
for the station to be forwarded.
Note In Table 22 on Page 179 , (tone) refers to three short tones used as a
confirmation tone and will play at that point in the sequence to confirm your
input was accepted.