T1
Installation Guidelines
8-8
Strata DK I&M 6/00
Figure 8-2
RDTU Printed Circuit Board
Installation Guidelines
1. Read
before proceeding to Step 2.
2. Run RDTU T1 related system programs as described in
.
3. Set P1 and P2, loop back jumper to the On position for RDTU self test (see
). Refer to
for the appropriate SW1
Equalizer Switch setting and set SW1 to the setting that matches the RDTU cable length.
4. Install the RDTU PCB per instructions
.
Note
Ensure the RDTU’s component side is facing right when installing it in the cabinet.
Table 8-1
RDTU Controls, Indicators, and Connectors
Control/Indicator/Connector
Type of Component
Description
SW1 Equalizer Setting Switch
8 2-position slide switches
Sets line length between RDTU and CSUs or
other T1 (max 655 ft.).
P3 (not used)
3-terminal jumper plug
This jumper plug is reserved for future use.
P4 Remote Loop Remote Mode
jumper plug
3-terminal jumper plug
Sets RDTU for Remote Loop Back mode test
procedure.
P1 and P2 Loop Back jumper plug
3-terminal jumper plug
Sets RDTU for self check or Network/CSU
loop back check.
4389
SD
RDER
SYCF
SYCF
SYCS
RST
CD1
CD2
CD3
CD4
CD5
ROMS1A
Female
Amphenol
Connector
Summary of Contents for Strata AirLink DK40i
