System & Station
Program 15 Assigning Exchange Line Attributes
3-36
Strata DK40 Programming Manual Spring 1999
On loop start Exchange lines, some local exchanges send an AR/CPC signal. If the system
Exchange line is on hold (or being transferred to another station or Auto Attendant port)
when the AR/CPC signal is sent, it is automatically disconnected if this option is activated.
Two-Exchange line DISA calls always release when AR/CPC is sent. DISA release via AR/
CPC is not related to this program. Exchange line calls disconnected by the AR/CPC signal
will be represented on the Station Message Detail Recording (SMDR) report by a “
*
” next to
the Exchange line number.
Important!
Enable AR/CPC-Hold detect on loop start lines only after testing that the
Exchange line sends the AR/CPC-Hold signal.
Code 4: Automatic Release (AR) Time
AR/CPC signalling timing is different depending on the local exchange
equipment.
For more information on AR/CPC, see the preceding Code 0 and Code 3 sections.
Systems installed in the UK should be set for 95 msecs (LED ON).
Code 5: Tandem Line Connection
Once a Two-line Conference call is made by an electronic or digital telephone users or voice
mail ports, the user or voice mail device may drop out of the conference and leave the two
lines connected. The choice exists for each line that may have this capability. This option
must be enabled to allow Exchange lines (loop/tie/DDI) to be used for outgoing DISA, Call
Forward External, and tie/DDI External Network routing calls.
Code 7: Forced Account Code (Verified or Non-verified)
If the Forced Account Code feature is used, (
) a station user is required to
enter an Account Code before a Exchange line call can be completed. A choice exists for
each line.
Code 8: Operation After Exchange Line Recall
If a standard telephone user is on an existing Exchange line call and flashes the hookswitch
on their telephone, a Dual-tone Multi-frequency (DTMF) receiver channel may or may not be
connected, depending on this assignment. If the Exchange line is a rotary dial only type, the
K5RCU must be seized after recall when dialling from DTMF standard telephones. The
K5RCU will decode the dialled tones and send dial pulses to the line.
Code 9: Recall Facility On AC15
This program enables or disables the sending and detection of a recall signal on AC15 TIE
lines. (This applies to the PACU units only).
